![]() Oregon identifies and labels all low-kickback chain with green labels and all NON low kickback chain with yellow labels. When replacing chain on saws less than 3.8 cubic inches (62cc), any low-kickback chain of the proper pitch and gauge can be used. ![]() Chainsaws with significantly reduced kickback potential are available.Be sure to read the labels on a chainsaw before purchasing one. Do not operate this chainsaw unless you have extraordinary cutting needs and experience and specialized training for dealing with kickback. 3.8 cubic inch (62cc) and larger, the chainsaw MAY OR MAY NOT meet low kickback provisions of the standard.Īny chainsaw that does not qualify as a low kickback cutting system will bear a warning such as: “WARNING – This chainsaw is capable of severe kickback that could result in serious injury to the user. Under 3.8 cubic-inch (62cc) engine displacement, the chainsaw MUST meet the low kickback provisions of the standard. The ANSI standard B175.1 divides all chainsaw power heads into two groups: The following information should be used as a guide for the selection of appropriate replacement chains in order to maintain compliance with the ANSI B175.1 standard (United States only). For more information go to Specifications, Details & SupportĬertain provisions of the safety standard known as ANSI (American National Standards Institute) B175.1 - Gasoline powered Chainsaws - Safety Requirements contain requirements designed to reduce the risk of injury from chainsaws sold in the United States.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |